Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
HNB-GW Service Configuration Mode Commands
paging open-hnb ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6115
paging open-hnb
Configures paging optimization parameters for open HNBs connected through Open Access mode in the HNB-GW
service instance. In this release it is used to configure paging optimization for Open Access mode support only. This
command is depricated release 15.0 onwards. Paging optimization can be configured using other
service instance. In this release it is used to configure paging optimization for Open Access mode support only. This
command is depricated release 15.0 onwards. Paging optimization can be configured using other
paging
commands
available in this chapter.
Important:
From Release14.0 and onward this command is part of HNB-Global Configuration Mode.
Important:
From Release 16 and later, this command has been deprecated.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnbgw-service)#
Syntax
paging open-hnb [hnb-where-ue-registered fallback ] {always | never | only-if-with-
paging-area}
paging-area}
default paging open-hnb
default
Sets the default behavior of paging optimization configuration for an open HNB while using Open Access
mode support.
By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.
mode support.
By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.
{
always
|
never
|
only-if-with-paging-area
}
Sets the HNB-GW service instance to page open HNB for a paging message.
always
: Sets the system to ALWAYS page the open HNBs irrespective of paging-area IE is received in
paging messages.
never
: Sets the system to NEVER page any open HNB.
only-if-with-paging-area
: Sets the system to page the open HNBs only when paging-area IE is
received in paging messages.
hnb-where-ue-registered fallback
{
always
|
never
|
only-if-with-paging-area
}
Sets the HNB-GW service instance to page open HNB from where the UE is registered.
always
: Sets the system to ALWAYS page the open HNBs from where the UE is registered. If the UE is not
registered then it pages the open HNBs irrespective of paging-area IE is received in paging messages.