Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Rulebase Configuration Mode Commands
▀ action priority
▄ Cisco ASR 5x00 Command Line Interface Reference
616
action priority
This command allows you to configure the action priority for a ruledef / group-of-ruledefs in the current rulebase.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
action priority action_priority { [ dynamic-only | static-and-dynamic | timedef
timedef_name ] { group-of-ruledefs ruledefs_group_name | ruledef ruledef_name } charging-
action charging_action_name [ monitoring-key monitoring_key ] [ description description ]
}
timedef_name ] { group-of-ruledefs ruledefs_group_name | ruledef ruledef_name } charging-
action charging_action_name [ monitoring-key monitoring_key ] [ description description ]
}
no action priority action_priority
no
If previously configured, deletes the specified action priority configuration from the current rulebase.
priority action_priority
Specifies a priority for the specified ruledef / group-of-ruledefs in the current rulebase.
action_priority
must be unique in the current rulebase, and must be an integer from 1 through 65535.
The priority controls the order in which this instance of the CLI command will be examined. Lower
numbered priorities are examined first. Up to 2048 instances may be configured, totaled among all rulebases.
numbered priorities are examined first. Up to 2048 instances may be configured, totaled among all rulebases.
Important:
If there are any changes to action priority and the Override Control/Inheritance feature is enabled,
then execute the CLI command “
update active-charging override-control rulebase-config
”. For more
information on this command, see the Command Line Interface Reference.
dynamic-only
Enables matching of dynamic rules with static rules for this action priority on a flow.
Configuring the
Configuring the
dynamic-only
keyword causes the configuration to be defined, but not enabled. If enabled,
the action associated with this option will not be matched against a flow until it is enabled from a dynamic
charging interface like Gx. Gx can disable or enable this action entry in the rulebase using Gx messages.
Default: Disabled
charging interface like Gx. Gx can disable or enable this action entry in the rulebase using Gx messages.
Default: Disabled
static-and-dynamic
The static-and-dynamic option causes the configuration to be defined and enabled, and allows a dynamic
protocol (such as the Gx interface) to disable or re-enable the configuration.
protocol (such as the Gx interface) to disable or re-enable the configuration.