Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Rulebase Configuration Mode Commands
egcdr threshold ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
657
egcdr threshold
This command allows you to configure the thresholds for generating eG-CDRs for GGSN and P-GW-CDRs for P-GW.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
egcdr threshold { interval interval [ regardless-of-other-triggers ] | volume { downlink
| total | uplink } bytes }
| total | uplink } bytes }
{ default | no } egcdr threshold { interval | volume }
no
If previously configured, deletes the eG-CDR threshold configuration from the current rulebase.
default
Configures this command with the default settings.
Default: Disabled; same as
Default: Disabled; same as
no egcdr threshold interval
and
no egcdr threshold interval
volume
commands.
interval interval [ regardless-of-other-triggers ]
Specifies the time interval, in seconds, for closing the eG-CDR/P-GW-CDR if the minimum time duration
thresholds are satisfied.
thresholds are satisfied.
interval
must be an integer from 60 through 40000000.
regardless-of-other-triggers
: This option enables eG-CDR/P-GW-CDR generation at the fixed time
interval irrespective of any other eG-CDR/P-GW-CDR triggers that may have happened in between.
Default: Disabled.
Default: Disabled.
volume { downlink | total | uplink } bytes
Specifies the uplink/downlink volume octet counts for the generation of the interim eG-CDRs/P-GW-CDRs.
downlink bytes
: Specifies the limit for the number of downlink (from network to subscriber) octets
after which the eG-CDR/P-GW-CDR is closed.
bytes
must be an integer from 100000 through 4000000000.
Default: 4000000000