Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Rulebase Configuration Mode Commands
extract-host-from-uri ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
663
extract-host-from-uri
This command allows you to configure whether to use the host name embedded in the URI as the host field, when the
host field option in the HTTP or Wireless Session Protocol (WSP) header is absent.
host field option in the HTTP or Wireless Session Protocol (WSP) header is absent.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
extract-host-from-uri { http | wsp ) +
{ default | no } extract-host-from-uri
default
Configures this command with its default setting.
Default: Disabled; same as
Default: Disabled; same as
no extract-host-from-uri
no
If previously configured, disables the extract-host-from-uri configuration, for both HTPP and WSP, from the
current rulebase.
current rulebase.
http | wsp
Specifies the protocol(s).
+
Indicates that more than one of the previous keywords can be entered within a single command.
Usage
If the host field is not present in HTTP/WSP header, this command will extract host from the URI, and store
it in the host field to enable “http host” and “wsp host” rule matches using the stored value.
it in the host field to enable “http host” and “wsp host” rule matches using the stored value.
Important:
Applying the
extract-host-from-uri
command a second time will overwrite the previous
configuration. For example, if you apply the command
extract-host-from-uri http wsp http
, and then apply
the command
extract-host-from-uri http wsp
, extraction of host from URI will happen only for WSP analyzer.
Example