Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
LTE Policy Configuration Mode Commands
▀ paging-map
▄ Cisco ASR 5x00 Command Line Interface Reference
6764
paging-map
Creates a paging map or specifies an existing paging map and enters the Paging Map Configuration Mode.
Product
MME
ePDG
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
[ no ] paging-map paging_map_name [ -noconfirm ]
no
Remove the paging map from the system.
paging_map_name
Specifies the name of the paging map being created or accessed. If the map name does not refer to an existing
map, a new map is created.
map, a new map is created.
paging_map_name
must be an alphanumeric string of 1 through 64 characters.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Enter the Paging Map Configuration Mode for an existing or newly defined map. This command is also used
to remove an existing map.
Entering this command results in the following prompt:
to remove an existing map.
Entering this command results in the following prompt:
hostname(paging-map)#
Paging Map Configuration Mode commands are defined in the LTE Paging Map Configuration Mode
Commands chapter.
Refer to the Heuristic and Intelligent Paging chapter in the MME Administration Guide for more information
about Paging Maps.
Commands chapter.
Refer to the Heuristic and Intelligent Paging chapter in the MME Administration Guide for more information
about Paging Maps.
Example
The following command enters the existing Paging Map Configuration Mode (or creates it if it does not
already exist) for the map named
already exist) for the map named
map1
:
paging-map map1