Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
MME Service Configuration Mode Commands
gtpv2 ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6905
gtpv2
Configures GTPv2 piggybacking support from the MME to the P-GW. A piggybacking flag is sent by the MME to a P-
GW in the S11 “Create Session Request” message and determines whether dedicated bearer creation (Create Bearer
Request) is piggybacked onto the “Create Session Response” message or not.
GW in the S11 “Create Session Request” message and determines whether dedicated bearer creation (Create Bearer
Request) is piggybacked onto the “Create Session Response” message or not.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
[ default | no ] gtpv2 piggybacking
default
Returns the command to its default setting of enabled.
no
Disables the feature.
piggybacking
Specifies that piggybacking is to be performed by the P-GW.
Usage
Use this command to enable the sending of a piggybacking flag to the P-GW over the S11 interface
requesting that the Create Bearer Request message is piggybacked on the Create Session Response message
(sent from the P-GW to the MME.
requesting that the Create Bearer Request message is piggybacked on the Create Session Response message
(sent from the P-GW to the MME.
Example
The following command disables this feature:
no gtpv2 piggybacking