Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
MME Service Configuration Mode Commands
▀ policy attach
▄ Cisco ASR 5x00 Command Line Interface Reference
6966
policy attach
Configures parameters for the UE Attach procedure.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
policy attach { imei-query-type { imei | imei-sv | none } [ verify-equipment-identity [
allow-on-eca-timeout | deny-greylisted | deny-unknown | verify-emergency ] ] | set-ue-
time { disable | enable [ prefer-mme | prefer-msc ] }
allow-on-eca-timeout | deny-greylisted | deny-unknown | verify-emergency ] ] | set-ue-
time { disable | enable [ prefer-mme | prefer-msc ] }
default policy attach { imei-query-type | set-ue-time }
default
Returns the command to its default setting of
none
for
imei-query-type
and
disabled
for
set-ue-
time
.
imei-query-type { imei | imei-sv | none }
Configures the IMEI query type for UE attach.
imei
: Specifies that the MME is required to query the UE for its International Mobile Equipment
Identity (IMEI).
imei-sv
: Specifies that the MME is required to query the UE for its International Mobile Equipment
Identity - Software Version (IMEI-SV).
none
: Specifies that the MME does not need to query for IMEI or IMEI-SV.
verify-equipment-identity [ allow-on-eca-timeout | deny-greylisted | deny-unknown
| verify-emergency ]
| verify-emergency ]
Specifies that the identification (IMEI or IMEI-SV) of the UE is to be performed by the Equipment Identity
Register (EIR) over the S13 interface.
Register (EIR) over the S13 interface.
allow-on-eca-timeout
: Configures the MME to allow equipment that has timed-out on ECA during
the attach procedure.
deny-greylisted
: Configures the MME to deny grey-listed equipment during the attach procedure.
deny-unknown
: Configures the MME to deny unknown equipment during the attach procedure.
verify-emergency
: Configures the MME to ignore the IMEI validation of the equipment during the
attach procedure in emergency cases. This keyword is only supported in release 12.2 and higher.