Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
MME Service Configuration Mode Commands
policy pdn-reconnection ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6975
policy pdn-reconnection
Configures the action by the MME when a PDN connection request to an already connected APN is being processed by
the MME service.
the MME service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
policy pdn-reconnection { multiple | reject | restart }
[ default ] policy pdn-reconnection
default
Sets the policy for PDN reconnection to its default behavior of Reject.
multiple
Allows multiple connections to a PDN with the same APN and PDN Type. In this case, the existing
connection is left unchanged, and the MME attempts to establish an additional connection to the PDN.
Default: Disabled
connection is left unchanged, and the MME attempts to establish an additional connection to the PDN.
Default: Disabled
reject
Configures the MME to deny or reject the request, by sending a PDN Connection Reject command. This is
the default behavior. Default: Enabled
the default behavior. Default: Enabled
restart
Deletes the existing connection and initiates an attempt to establish a new connection. Default: Disabled
Usage
Use this command to set the user-defined policies for PDN reconnection attempt procedures initiated by a UE
in an MME service.
While attached the UE can request connections to PDNs. The PDNs are identified by APN (Access Point
Name) and PDN Type (ipv4, ipv6 or ipv4v6).
If the UE requests connection to a PDN for which a connection with the same APN name and PDN type
already exists, the MME can: 1) deny or reject the request, by sending a PDN connection reject command; 2)
in an MME service.
While attached the UE can request connections to PDNs. The PDNs are identified by APN (Access Point
Name) and PDN Type (ipv4, ipv6 or ipv4v6).
If the UE requests connection to a PDN for which a connection with the same APN name and PDN type
already exists, the MME can: 1) deny or reject the request, by sending a PDN connection reject command; 2)