Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Rulebase Configuration Mode Commands
pcp service ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
709
pcp service
This command allows you to configure the PCP service for the current rulebase.
Important:
This command is customer specific. Contact your Cisco account representative for more information.
Product
NAT
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
pcp service pcp_service_name
no pcp service
no
If previously configured, deletes the PCP service configuration from the current rulebase. This service is
disabled by default.
disabled by default.
pcp_service_name
Specifies the PCP service name for the current rulebase.
pcp_service_name
must be the name of a PCP service, and must be an alphanumeric string of 1 through 63
characters.
Usage
Use this command to configure the PCP service for the current rulebase.
Example
The following command configures a PCP service named
pcp1
for the rulebase:
pcp service pcp1