Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
OSPF Configuration Mode Commands
▀ area virtual link intervals
▄ Cisco ASR 5x00 Command Line Interface Reference
7126
area virtual link intervals
Configures the interval or delay type, and the delay time in seconds, for the virtual link between an area that cannot be
physically connected to the network backbone and an area that is physically connected to the network backbone.
physically connected to the network backbone and an area that is physically connected to the network backbone.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > OSPF Configuration
configure > context context_name > router ospf
Entering the above command sequence results in the following prompt:
[local]host_name(config-ospf)#
Syntax
[ no ] area { ipaddress | decimal_value } virtual-link router_id_address [ dead-interval
value ] [ hello-interval value ] [ retransmit-interval value ] [ transmit-delay value ]
value ] [ hello-interval value ] [ retransmit-interval value ] [ transmit-delay value ]
no
Disables the area virtual link intervals.
ipaddress
Specifies the IP address of the area in IPv4 dotted-decimal notation.
decimal-value
Specifies the identification number of the transit area as an integer from 0 through 4294967295.
router_id_address
Specifies the router id of the ABR to be linked to in IPv4 dotted-decimal notation.
dead-interval
value
Specifies The interval (in seconds) that the router should wait, during which time no packets are received and
after the router considers a neighboring router to be off-line.
after the router considers a neighboring router to be off-line.
value
must be an integer from 1 through 65535.
hello-interval
value
Specifies the interval (in seconds) before sending a hello packet.
value
must be an integer from 1 through
65535.