Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
S-GW Service Configuration Mode Commands
gtpu-error-ind ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
8157
gtpu-error-ind
Configures the actions to be taken upon receiving a GTP-U error indication from an RNC, eNodeB, SGSN, or P-GW.
Product
S-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
gtpu-error-ind { { s12 | s1u } { local-purge | page-ue [ custom1-behavior ] } | { s4u |
s5u } { local-purge | signal-peer } }
s5u } { local-purge | signal-peer } }
default gtpu-error-ind { s12 | s1u | s4u | s5u }
default
Resets the command to the default action for the specified interface. For S12 and S1-U,
page-ue
is the
default action. For S4-U and S5-U,
local-purge
is the default action.
{ s12 | s1u } { local-purge | page-ue [ custom1-behavior ] }
Specifies the action to take when a GTP-U error indication is received from a Radio Network Controller
(RNC) over an S12 interface or from an eNodeB over the S1-U interface.
(RNC) over an S12 interface or from an eNodeB over the S1-U interface.
local-purge
: The S-GW clears the affected bearer (or PDN if error-indication is received on default
bearer) locally without informing peer.
page-ue [ custom1-behavior ]
: The S-GW moves the complete UE state to S1-Idle and starts paging
for this UE. If the custom1-behavior option is specified, the S-GW will guard the paging attempt with a timer
of 60 seconds. Within this time the bearer must have the eNodeB TEID refreshed by an MME. Otherwise, the
S-GW will clear the affected bearer with signaling. This is the default action for GTP-U error indication
messages received on the S12 and S1-U interfaces.
of 60 seconds. Within this time the bearer must have the eNodeB TEID refreshed by an MME. Otherwise, the
S-GW will clear the affected bearer with signaling. This is the default action for GTP-U error indication
messages received on the S12 and S1-U interfaces.
{ s4u | s5u } { local-purge | signal-peer }
Specifies the action to take when a GTP-U error indication is received from an SGSN over an S4-U interface
or from a P-GW over the S5-U interface.
or from a P-GW over the S5-U interface.
local-purge
: The S-GW clears the affected bearer (or PDN if error-indication is received on a default
bearer) locally without informing the peer. This is the default action for GTP-U error indication messages
received on the S4-U and S5-U interfaces.
received on the S4-U and S5-U interfaces.
signal-peer
: The S-GW initiates control signalling towards the peer MME and P-GW. When signalling:
For a bearer deletion, the S-GW sends a Delete-Bearer-Command message to the P-GW and a Delete-
Bearer-Request (with EBI) message to the MME.