Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
S-GW Service Configuration Mode Commands
timeout idle ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
8167
timeout idle
This command removes S-GW sessions that remain idle for longer than the configured time limit.
Product
S-GW
SAE-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
timeoutidle dur_seconds
timeout idle
Enables the S-GW session idle timer.
dur_seconds
Specifies the time limit, in seconds, after which the SGW session will be torn down. Valid entries are from 0
to 4294967295.
to 4294967295.
Usage
The S-GW session idle timer removes stale sessions in those cases where the session is removed on the other
nodes but due to some issue remains on the S-GW. Once configured, the session idle timer will tear down
such sessions that remain idle for longer than the configured time limit. The implementation of the session
idle timer allows the S-GW to more effectively utilize system capacity.
nodes but due to some issue remains on the S-GW. Once configured, the session idle timer will tear down
such sessions that remain idle for longer than the configured time limit. The implementation of the session
idle timer allows the S-GW to more effectively utilize system capacity.
Example
The following example configures the S-GW session idle timer 3600 seconds (one minute).
timeout idle 3600