Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Subscriber Configuration Mode Commands
ip access-group ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
8261
ip access-group
Configures IP access group for the current subscriber.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
[ no ] ip access-group group_name [ in | out ]
no
Indicates the access group specified is to be cleared from the subscribers configuration.
ip access-group
group_name
Specifies the name of the IPv4/IPv6 access group.
acl_group_name
is a configured ACL group expressed
as an alphanumeric string of 1 through 79 characters.
in
|
out
Default: both (in and out)
Specifies the access-group as either inbound or outbound by the keywords
Specifies the access-group as either inbound or outbound by the keywords
in
and
out
, respectively. If
neither of these key words is specified, the command associates the
group_name
access group with the
current subscriber for both inbound and outbound access.
Usage
Set the subscriber access group to manage the access control for subscribers as a logical group.
Example
The following command associates the
sampleGroup
access group with the current subscriber for both
inbound and outbound access:
ip access-group sampleGroup
The following removes the outbound access group flag for
sampleGroup
:
no ip access-group sampleGroup out