Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Traffic Policy-Map Configuration Mode Commands
▀ qos traffic-police
▄ Cisco ASR 5x00 Command Line Interface Reference
8416
qos traffic-police
Enables and configures Quality of Service (QoS) policy for flow-based traffic policing of subscriber session flows on a
per-flow basis.
per-flow basis.
Product
ASN-GW
HA
HSGW
PDSN
P-GW
SAEGW
SCM
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Traffic Policy Map Configuration
configure > context context_name > policy-map name map_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-policy-map)#
Syntax
qos traffic-police committed bps peak bps burst-size byte exceed-action { drop | lower-
ip-precedence | allow } violate-action { drop | lower-ip-precedence | allow }
ip-precedence | allow } violate-action { drop | lower-ip-precedence | allow }
no qos traffic-police
no
Enables/Disables the
qos traffic-police
Important:
This parameter should be configured to be greater than the following two values: 1) three times
greater than packet MTU for the subscriber connection, OR 2) three seconds worth of token accumulation within the
“bucket” for the configured peak-data-rate.
“bucket” for the configured peak-data-rate.
burst-size
bytes
Default: 3000
Specifies the allowed peak burst size in bytes.
Specifies the allowed peak burst size in bytes.
bytes
must be an integer from 0 through 4294967295.
Important:
This parameter should be configured to be greater than the following two values: 1) three times
greater than the packet MTU for the subscriber connection, OR 2) three seconds worth of token accumulation within the
“bucket” for the configured peak-data-rate.
“bucket” for the configured peak-data-rate.