Cisco Cisco Packet Data Interworking Function (PDIF)
show card
▀
▄ Statistics and Counters Reference, StarOS Release 16
3664
Field
Description
BCF
Board Control FPGA firmware.
Fabric and Storage Card (FSC)
Card Programmables
Indicates if the software on any of the programmable components on the card is
not at the current revision.
“up to date” – all software is current
“out of date” – identifies one or more components do not have the most current
software.
“experimental/unreleased” – one or more components have experimental or
unreleased software.
not at the current revision.
“up to date” – all software is current
“out of date” – identifies one or more components do not have the most current
software.
“experimental/unreleased” – one or more components have experimental or
unreleased software.
BCF
Board Control FPGA firmware.
show card info (ASR 5000)
Table 231.
show card info (ASR 5000)
Command Output Descriptions
Field
Applicable
Card(s)
Card(s)
Description
Slot Type
All
Displays the acronym for the card type.
Card Type
All
Indicates the type of card installed.
Operational
State
State
All
Displays the operational state of the card. The possible operational states
are:
are:
Active: Indicates that the card is an active component that will be
used to process subscriber data sessions.
used to process subscriber data sessions.
Standby: Indicates that the card is a redundant component.
Redundant components will become active through manual
configuration or automatically should a failure occur.
Redundant components will become active through manual
configuration or automatically should a failure occur.
Offline: Indicates that the card is installed but is not ready to
process subscriber data sessions. This could be because it is not
completely installed (such as, the card interlock switch is not
locked}. Refer to the ASR 5000 Installation Guide for additional
information.
process subscriber data sessions. This could be because it is not
completely installed (such as, the card interlock switch is not
locked}. Refer to the ASR 5000 Installation Guide for additional
information.
Desired Mode
Processing
Cards, SPIOs
and line cards
only
Cards, SPIOs
and line cards
only
Displays the configured mode of the card. Through software configuration
the card could be placed into either the active or standby mode.
the card could be placed into either the active or standby mode.