Cisco Cisco Packet Data Interworking Function (PDIF)
Access Control Lists
▀ Applying IP ACLs
▄ VPC-VSM System Administration Guide, StarOS Release 19
180
{ ip | ipv6 } access-group acl_list_name { in | out } [ preference ]
end
Notes:
The context name is the name of the ACL context containing the interface to which the ACL is to be applied.
The ACL to be applied must be configured in the context specified by this command.
Up to eight ACLs can be applied to a group provided that the number of rules configured within the ACL(s) does
not exceed the 128-rule limit for the interface.
Verifying the ACL Configuration on an Interface
This section describes how to verify the ACL configuration.
Step 1
In the Exec Mode, enter the following command:
[local]host_name# show configuration context context_name
context_name is the name of the context containing the interface to which the ACL(s) was/were applied.
The output of this command displays the configuration of the entire context. Examine the output for the commands
pertaining to interface configuration. The commands display the ACL(s) applied using this procedure.
pertaining to interface configuration. The commands display the ACL(s) applied using this procedure.
configure
context context_name
ip access-list acl_name
deny host ip_address
deny ip any host ip_address
exit
ip access-group access_group_name
service-redundancy-protocol
exit
interface interface_name
ip address ip_address/mask
exit
subscriber default
exit
aaa group default
exit