Cisco Cisco Packet Data Interworking Function (PDIF)
SNMP Configuration
▀ SNMP Support
▄ VPC-VSM System Administration Guide, StarOS Release 19
70
SNMP Support
StarOS uses the SNMP to send traps or events to alarm servers on the network. You must configure SNMP settings to
communicate with those devices.
communicate with those devices.
Important:
Commands used in the configuration samples in this section provide base functionality. The most
common commands and keyword options are presented. In many cases, other optional commands and keyword options
are available. Refer to the Command Line Interface Reference for complete information.
are available. Refer to the Command Line Interface Reference for complete information.
The SNMP MIB Reference describes the MIBs and SNMP traps supported by StarOS.
To configure the system to communicate with an alarm server:
Step 1
Set SNMP parameters such as UDP port, and alarm server target by applying the example configuration in
Step 2
To view your new SNMP configuration, follow the steps in
Step 3
Save the configuration as described in the Verifying and Saving Your Configuration chapter.