Cisco Cisco Packet Data Interworking Function (PDIF) Notas De La Versión
System Changes in Release 15.0
System and Platform Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
611
Important:
An SNMP trap is generated when an administrator enters or edits a password via this command
(starTechSupportPasswordChanged).
Important:
Access to the
cli test-commands
command also requires that a Security Administrator or
Administrator enabled the Global Configuration mode
cli hidden
command.
Modified System Commands
This section identifies system commands modified in release 15.0.
clear task resources max
A new max keyword has been added to the clear task resources command. It clears just the maximum usage levels for
tasks as opposed to all current usage levels.
tasks as opposed to all current usage levels.
clear task resources { card card_num { facility facility { all | instance id max } |
facility facility { all | instance id max } | max }
facility facility { all | instance id max } | max }
delta-route-modifier
Specifies the delta that will be used to compute the route modifier difference between the active and standby chassis.
Prior to this release, the delta is applied only in the standby state. For this release, it is used in both states.
Prior to this release, the delta is applied only in the standby state. For this release, it is used in both states.
configure
configure context ctx_name
service-redundancy-protocol
delta-route-modifier value
end
ipv6 prefix pool
A prefix-length option has been added to this command to set configured prefix lengths of 48, 52, 56 or 64 bits. The
default is 64 bits. This option supports S-GW/P-GW validation of fixed-length addresses via DHCPv6 (TS 29.274 –
7.2.2 and 8.14).
default is 64 bits. This option supports S-GW/P-GW validation of fixed-length addresses via DHCPv6 (TS 29.274 –
7.2.2 and 8.14).
configure
configure context ctx_name
ipv6 pool name range ipv6_address prefix-length prfx_length
end
monitor authentication-probe