Cisco Cisco WAP2000 Wireless-G Access Point - PoE Manual De Mantenimiento

Back Panel

Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide

6

 

Ethernet—(Green) Lights up when the access point successfully connects to a 
device through the Ethernet network port. This LED flashes when the access point 
is actively sending to or receiving data from one of the devices over the Ethernet 
network port.

The antenna ports, Reset button, Ethernet port, and power port are located on the 
back panel.

Antenna Ports—The access point has two antenna ports for connecting 
detachable 3 dBi omnidirectional antennas. Adjust the two antennas so that they 
form a 90 degree angle for best MIMO range performance. 

RESET Button—There are two ways to reset the access point to the factory 
default configuration. Either press the Reset button for more than ten seconds or 
restore the defaults using the web-based utility of the access point. If you press 
the Reset button for less than ten seconds, the access point will simply reboot.

ETHERNET Port—Connects to Ethernet network devices, such as a switch or 
router. The access point can be powered using Power over Ethernet. 

POWER Port—Connects the access point to power using the supplied power 
adapter. Use this option if your switch or router doesn’t support Power over 
Ethernet.