Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup Guía De Instalación
25
Regulatory Compliance and Safety Information for the Cisco WAP371 Wireless Access Point (EMC Class B Devices)
78-20515-02
EMC Class B Notices and Warnings
For specific details about the years, revisions and relevant amendments please refer to the applicable
declaration of conformity available at
declaration of conformity available at
EMC Class B Notices and Warnings
This section includes the EMC Class B warnings for the Cisco WAP371 Wireless Access Point.
Class B Notice for FCC
Modifying the equipment without Cisco’s authorization may result in the equipment no longer
complying with FCC requirements for Class B digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
complying with FCC requirements for Class B digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
EMC
47CFR FCC Part 15B
Industry Canada ICES-003
EN 301 489-1, EN 301 489-17
EN 300 386
EN55022
EN55024
EN61000-3-2
EN61000-3-3
CISPR 22
CISPR 24
AS/NZS CISPR22
Radio
47CFR FCC Part 15C
Industry Canada RSS-210
EN 300 328
EN 301893
AS/NZS 4268
RF Exposure
FCC OET 65, Supplement C
RSS-102
EN 50385
Table 1
(continued)
Specification
Description