Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup Manual De Mantenimiento

Getting Started

Using the Access Point Setup Wizard

Cisco Small Business WAP371 Wireless Access Point Administration Guide 

3

1

address can also be specified as the subnet IP address, so that all addresses in the 
subnet are added to the local intranet zone.

•

If you have multiple IPv6 interfaces on your management station, use the IPv6 global 
address instead of the IPv6 local address to access the AP from your browser.

By default, the web-based AP configuration utility logs out after 10 minutes of inactivity. See 

 for instructions on changing the default timeout period.

To log out, click Logout in the top right corner of the web-based AP configuration utility.

Using the Access Point Setup Wizard

The first time that you log into the AP (or after it has been reset to the factory default settings), 
the Access Point Setup Wizard appears to help you perform initial configurations. Follow 
these steps to complete the wizard:

NOTE

If you click Cancel to bypass the Wizard, the Change Password page appears. You can then 
change the default password for logging in. For all other settings, the factory default 
configurations apply.

You must log in again after changing your password.

STEP 1

Click Next on the Welcome page of the Wizard. The Configure Device - IP Address window 
appears.

STEP  2

Click

 

Dynamic IP Address (DHCP) if you want the WAP device to receive an IP address from 

a DHCP server. Or select Static IP Address to configure IP Address manually. For a 
description of these fields, see 

.

STEP  3

Click Next. The Single Point Setup — Set a Cluster window appears. For a description of 
Single Point Setup, see 

STEP  4

To create a new Single Point Setup of WAP devices, select Create a New Cluster and specify a 
New Cluster Name. When you configure your devices with the same cluster name and enable 
Single Point Setup mode on other WAP devices, they automatically join the group.