Cisco Cisco WAP321 Wireless-N Access Point with Single Point Setup Guía De Instalación

Descargar
Página de 33
 
32
Regulatory Compliance and Safety Information for the Cisco WAP321 Wireless Access Point (EMC Class B Devices)
78-20515-02
  Generic Discussion on RF Exposure
English Translation
Administrative Rules for Low-Power Radio-Frequency Devices
Article 12
For those low-power radio-frequency devices that have already received a type-approval, companies, 
business units, or users should not change its frequencies, increase its power, or change its original 
features and functions.
Article 14
The operation of the low-power radio-frequency devices is subject to the conditions that no harmful 
interference is caused to aviation safety and authorized radio stations; and if interference is caused, the 
user must stop operating the device immediately and can’t re-operate it until the harmful interference is 
clear.
The authorized radio station means a radio-communication service operating in accordance with the 
Communication Act.
The operation of the low-power radio-frequency devices is subject to the interference caused by the 
operation of an authorized radio station, by another intentional or unintentional radiator, by industrial, 
scientific and medical (ISM) equipment, or by an incidental radiator.
Generic Discussion on RF Exposure
The Cisco WAP321 Wireless Access Points are designed to comply with the following national and 
international standards on Human Exposure to Radio Frequencies.
  •
US 47 Code of Federal Regulations Part 2 Subpart J
  •
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / 
IEEE C 95.1 (92)
  •
International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
  •
Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields 
in the range from 3kHz to 300 GHz
  •
Australia Radiation Protection Standard
To ensure compliance with various national and international Electromagnetic Field (EMF) standards,  
the system should only be operated with Cisco approved antennas and accessories.
US
This system has been evaluated for RF exposure for Humans in reference to ANSI C 95.1 (American 
National Standards Institute) limits.  The evaluation was based on evaluation per ANI C 95.1 and FCC 
OET Bulletin 65C rev 01.01.  The minimum separation distance from the antenna to general bystander 
is 7.9 inches (20cm) to maintain compliance.
Canada
This system has been evaluated for RF Exposure per RSS-102 and is in compliance with the limits 
specified by Health Canada Safety Code 6. The system must be installed at a minimum separation 
distance from the antenna to a general bystander of 7.9 inches (20 cm) to maintain compliance with the 
General Populace limits.
L'exposition aux radiofréquences de ce système a été évaluée selon la norme RSS-102 et est jugée 
conforme aux limites établies par le Code de sécurité 6 de Santé Canada. Le système doit être installé 
à une distance minimale de 7,9 pouces (20 cm) séparant l'antenne d'une personne présente en 
conformité avec les limites permises d'exposition du grand public.