Cisco Cisco WAP2000 Wireless-G Access Point - PoE Notas de publicación
2
Release Notes for Cisco WAP2000 Wireless-G Access Point with PoE Firmware Version 2.0.6.0
Release Notes
NOTE
When configuring this device, be aware that the default IP settings changed from
static IP to DHCP in firmware version 2.0.3.4 and later releases.
static IP to DHCP in firmware version 2.0.3.4 and later releases.
Changes in Firmware Version 2.0.6.0
Open Issue
Performing a factory reset via the GUI may take an extended time to complete
depending on your configuration.
depending on your configuration.
For a workaround, if the reset does not complete after 5 mins, perform a hard reset
by pushing the reset button on the back of the unit as described in the user
docmentation.
by pushing the reset button on the back of the unit as described in the user
docmentation.
Other Updates
The following problems were fixed in firmware version 2.0.6.0:
•
GUI—RADIUS Server port no longer accepts various illegal values for the
port range.
port range.
•
GUI—RADIUS Server IP address no longer accepts leading zeros.
•
GUI—DHCP Auto Configuration process has been optimized.
Changes in Firmware Version 2.0.5.0
Open Issue
When enabling or disabling multiple VLAN IDs, the GUI cannot be redirected as
usual. This has been tested with IE6, IE7, and Mozilla Firefox.
usual. This has been tested with IE6, IE7, and Mozilla Firefox.
Other Updates
The following problems were fixed in firmware version 2.0.5.0: