Cisco Cisco WAP2000 Wireless-G Access Point - PoE Notas de publicación

2

Release Notes for Cisco WAP2000 Wireless-G Access Point with PoE Firmware Version 2.0.5.0

When enabling or disabling multiple VLAN IDs, the GUI cannot be redirected as 
usual. This has been tested with IE6, IE7, and Mozilla Firefox.

The following problems were fixed in firmware version 2.0.5.0:

•

GUI—The verification of the listed items with NTP Server IP, SNMP Trusted 
Host, SNMP Trap-Destination, and Syslog Server IP address(es):

-

Allow leading zeros.

-

Modify the error message “Invalid value for IP address! Please, specify a 
value between 1 and 223” because this message for the host IP input is 
not clear. The system is actually verifying the first IP address is between 
1 and 223.

-

The fourth IP address rule does not allow 0 and 255 to ensure the host 
assignment.

•

Administration—DHCP Auto Configuration: Backup TFTP server with IP 
address option accepts non-ucast IP address range (the first octet is 
outside of 1-223).

•

Setup > Basic Setup—Static IP Address cannot block 0 and 255 in the first 
value of the DNS IP Address.

•

Wireless > Basic Settings—Limit SSID length to 31 characters.

•

Wireless > Security—The fourth RADIUS Server IP address can accept 
0 and 255.

•

Wireless > Basic Settings—Modify alert message when SSID includes a 
blank character.

•

Wireless > SSID—When adding SSID 3 or 4 and then clicking Cancel, 
SSID 3 and 4 display Enabled SSID Broadcast.

•

Wireless > Security—The RADIUS Server port can accept 99999.

•

VLAN—DUT can accept 4095 as a VLAN ID.