Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manual De Mantenimiento
Wireless
Quality of Service
Cisco WAP131 and WAP351 Administration Guide
111
5
After the Maximum Contention Window size is reached, retries continue until
a maximum number of retries allowed is reached.
a maximum number of retries allowed is reached.
Valid values are 1, 3, 7, 15, 31, 63, 127, 255, 511, or 1024. This value must be
higher than the value for the Minimum Contention Window.
higher than the value for the Minimum Contention Window.
•
Maximum Burst—A WAP EDCA parameter that applies only to traffic
flowing from the WAP to the client station.
flowing from the WAP to the client station.
This value specifies (in milliseconds) the maximum burst length allowed for
packet bursts on the wireless network. A packet burst is a collection of
multiple frames transmitted without header information. The decreased
overhead results in higher throughput and better performance. Valid values
are 0.0 through 999.
packet bursts on the wireless network. A packet burst is a collection of
multiple frames transmitted without header information. The decreased
overhead results in higher throughput and better performance. Valid values
are 0.0 through 999.
•
Wi-Fi MultiMedia (WMM)—Select Enable to enable Wi-Fi MultiMedia
(WMM) extensions. This field is enabled by default. With WMM enabled, QoS
prioritization and coordination of wireless medium access is on. With WMM
enabled, QoS settings on the WAP device control downstream traffic
flowing from the WAP device to client station (AP EDCA parameters) and the
upstream traffic flowing from the station to the AP (station EDCA
parameters).
(WMM) extensions. This field is enabled by default. With WMM enabled, QoS
prioritization and coordination of wireless medium access is on. With WMM
enabled, QoS settings on the WAP device control downstream traffic
flowing from the WAP device to client station (AP EDCA parameters) and the
upstream traffic flowing from the station to the AP (station EDCA
parameters).
Disabling WMM deactivates QoS control of station EDCA parameters on
upstream traffic flowing from the station to the WAP device. With WMM
disabled, you can still set some parameters on the downstream traffic
flowing from the WAP device to the client station (AP EDCA parameters).
upstream traffic flowing from the station to the WAP device. With WMM
disabled, you can still set some parameters on the downstream traffic
flowing from the WAP device to the client station (AP EDCA parameters).
•
TXOP Limit (Station only)—The TXOP Limit is a station EDCA parameter and
only applies to traffic flowing from the client station to the WAP device. The
Transmission Opportunity (TXOP) is an interval of time, in milliseconds, when
a WME client station has the right to initiate transmissions onto the wireless
medium (WM) towards the WAP device. The TXOP Limit maximum value is
65535.
only applies to traffic flowing from the client station to the WAP device. The
Transmission Opportunity (TXOP) is an interval of time, in milliseconds, when
a WME client station has the right to initiate transmissions onto the wireless
medium (WM) towards the WAP device. The TXOP Limit maximum value is
65535.
STEP 5
Configure the following additional settings:
•
No Acknowledgement—Check Enable to specify that the WAP device
should not acknowledge frames with QosNoAck as the service class value.
should not acknowledge frames with QosNoAck as the service class value.
•
Unscheduled Automatic Power Save Delivery—Check Enable to enable
APSD, which is a power management method. APSD is recommended if
VoIP phones access the network through the WAP device.
APSD, which is a power management method. APSD is recommended if
VoIP phones access the network through the WAP device.
STEP 6
Click Save. The changes are saved to the Startup Configuration.