Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manual De Mantenimiento

Class Map

Cisco WAP131 and WAP351 Administration Guide

132

•

Destination Port—Includes a destination port in the match condition for the 
rule. The destination port is identified in the datagram header.

-

Select From List—Matches the destination port in the datagram header 
with the selected keyword: ftp, ftpdata, http, smtp, snmp, telnet, tftp, 
www. Each of these keywords translates into its equivalent port number.

-

Match to Port—Matches the destination port in the datagram header 
with an IANA port number that you specify. The port range is from 0 to 
65535 and includes three different types of ports:

0 to 1023—Well Known Ports

1024 to 49151—Registered Ports

49152 to 65535—Dynamic and/or Private Ports

-

Mask—The port mask. The mask determines which bits are used and 
which bits are ignored. Only the hexadecimal digit (0 to 0xFFFF) is 
allowed. 1 means the bit matters and 0 means that we should ignore this 
bit.

•

IPv6 Flow Label—Enter a 20-bit number that is unique to an IPv6 packet. It 
is used by end stations to signify QoS handling in routers (range 0 to 
1048575).

•

IP DSCP—Uses the DSCP value as a match criterion. 

-

Select from List—Choose the DSCP type from the list.

-

Match to Value—Enter a custom DSCP value from 0 to 63.

Click Save. The changes are saved to the Startup Configuration.

To delete a class map, choose it in the Class Map Name list and click Delete. The 
class map cannot be deleted if it is already attached to a policy.

To add and configure a MAC class map:

Select Quality of Service > Class Map.

In the Class Map Name field, enter the name for the new class map. The name can 
contain from 1 to 31 alphanumeric and special characters. Spaces are not 
allowed.