Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manual De Mantenimiento

Instance Configuration

Cisco WAP131 and WAP351 Administration Guide

162

An away timeout value is also configured for each user (see the 

 page). The away timeout value set on the Local Groups/

Users page has precedence over the value configured here, unless the value 
is set to 0 (the default). A value of 0 indicates to use the instance timeout 
value.

•

Session Timeout—Enter the time remaining, in seconds, for the CP session 
to be valid. After the time reaches zero, the client is deauthenticated. The 
range is from 0 to 1440 minutes. The default value is 0.

•

Maximum Bandwidth Upstream—Enter the maximum upload speed, in 
megabits per second, that a client can transmit traffic when using the 
Captive Portal. This setting limits the bandwidth at which the client can send 
data into the network. The range is from 0 to 300 Mbps. The default value is 
0.

•

Maximum Bandwidth Downstream—Enter the maximum download speed, 
in megabits per second, that a client can receive traffic when using the 
Captive Portal. This setting limits the bandwidth at which the client can 
receive data from the network. The range is from 0 to 300 Mbps. The default 
value is 0.

•

User Group Name—If the Verification mode is set to Local or RADIUS, 
assigns an existing user group to the CP instance. All users who belong to 
the group are permitted to access the network through this portal.

•

RADIUS IP Network—Choose if the WAP RADIUS client uses the 
configured IPv4 or IPv6 RADIUS server addresses.

•

Global RADIUS—If the Verification mode is set to RADIUS, check Enable to 
use the default global RADIUS server list to authenticate the clients. (See 

 for information about configuring the global RADIUS 

servers.) If you want the CP feature to use a different set of RADIUS servers, 
uncheck the box and configure the servers in the fields on this page.

•

RADIUS Accounting—Check Enable to track and measure the resources 
that a particular user has consumed, such as the system time and the amount 
of data transmitted and received.

If you enable RADIUS accounting, it is enabled for the primary RADIUS 
server, all backup servers, and the globally or locally configured servers.

•

Server IP Address 1 or Server IPv6 Address 1—Enter the IPv4 or IPv6 
address for the primary RADIUS server for this VAP. The IPv4 address should 
be in a form similar to xxx.xxx.xxx.xxx (192.0.2.10). The IPv6 address should 
be in a form similar to xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx 
(2001:DB8:CAD5:7D91).