Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manual De Mantenimiento

Rogue AP Detection

Cisco WAP131 and WAP351 Administration Guide

83

-

On—Indicates that the rogue device has some security in place. You can 
use the 

 page to configure the security settings on the WAP 

device.

•

WPA—Shows whether the WPA security is on or off for the rogue AP.

•

Band—The IEEE 802.11 mode being used on the rogue AP, such as IEEE 
802.11a, IEEE 802.11b, IEEE 802.11g.

The number shown indicates the mode: 

-

2.4 indicates IEEE 802.11b, 802.11g, or 802.11n mode (or a combination 
of the modes).

-

5 indicates IEEE 802.11a or 802.11n mode (or both modes).

•

Channel—The channel on which the rogue AP is currently broadcasting. The 
channel defines the portion of the radio spectrum that the radio uses for 
transmitting and receiving. You can use the 

 page to set the channel.

•

Rate—The rate in megabits per second at which the rogue AP is currently 
transmitting. The current rate is always one of the rates shown in the 
Supported Rates field.

•

Signal—The strength of the radio signal emitting from the rogue AP. If you 
hover the mouse pointer over the bars, a number representing the strength 
in decibels (dB) appears.

•

Beacons—The total number of beacons received from the rogue AP since it 
was first discovered. 

•

Last Beacon—The date and time of the last beacon received from the rogue 
AP.

•

Rates—Supported and basic (advertised) rate sets for the rogue AP. Rates 
are shown in megabits per second (Mbps). All Supported Rates are listed, 
with Basic Rates shown in bold. Rate sets are configured on the 

 page.

If the AP is in the Detected Rogue AP List, click Trust to move the AP to the 
Trusted AP List. If the AP is in the Trusted AP List, click Untrust to move the AP to 
the Detected Rogue AP List. 

Click Refresh to refresh the screen and show the most current information.