Cisco Cisco Aironet 1200 Access Point Notas de publicación
12
Release Notes for Cisco Aironet Conversion Tool Version 2.1 for Cisco IOS Software
OL-6225-01
Caveats
•
Data Beacon Rate (DTIM) settings range from 1 to 100. If the configured setting is greater than 100,
the migrated setting is 100.
the migrated setting is 100.
•
Beacon Period settings range from 20 to 4000. If the configured setting is greater than 4000, the
migrated setting is 4000 and if the configured setting is less than 20, the migrated setting is 20.
migrated setting is 4000 and if the configured setting is less than 20, the migrated setting is 20.
•
WEP Key Rotation Interval settings range from 1 to 10. If the configured setting is greater than 10,
the migrated setting is 10.
the migrated setting is 10.
•
If the configured settings for the LEAP or EAP transmit key is not set to Key 1, the following error
is produced by Cisco IOS software in the migrated configuration:
is produced by Cisco IOS software in the migrated configuration:
–
Error: LEAP/EAP authentication does not support the key index#.
•
If the configured setting for DSCP is not a specific value (0, 1, 2, 3, 4, 5, 6, 7, 11, 12, 12, 21, 22, 23,
31, 32, 33, 41, 42, or 43), the following error is produced by Cisco IOS software in the migrated
configuration when viewing the settings using the HTTP interface:
31, 32, 33, 41, 42, or 43), the following error is produced by Cisco IOS software in the migrated
configuration when viewing the settings using the HTTP interface:
–
Policy_policy_fallback_policy was created using CLI. It must be deleted via CLI to ensure
proper operation of the web interface.
proper operation of the web interface.
Note
Even though this error message is displayed, the migrated configuration and the associated
functionality are correct.
functionality are correct.
•
If host names are used for RADIUS, accounting, and NTP servers, the converted Cisco IOS access
points are unable to use DNS to obtain the corresponding IP addresses. Cisco recommends that you
change your VxWorks configurations to use IP addresses rather than host names for RADIUS,
accounting, and NTP servers, or to configure the servers after the converted access points boot up.
points are unable to use DNS to obtain the corresponding IP addresses. Cisco recommends that you
change your VxWorks configurations to use IP addresses rather than host names for RADIUS,
accounting, and NTP servers, or to configure the servers after the converted access points boot up.
•
If a Native VLAN is not configured, an error warning message is displayed.
Caveats
Open Caveats
There are no open caveats.
Resolved Caveats
The following caveats have been resolved:
•
CSCef00958—The config.txt file on 350 series access points might be removed after conversion to
Cisco IOS operation using the conversion tool.
Cisco IOS operation using the conversion tool.
•
CSCef01859—The conversion tool should provide a free memory check for deployed access points.