Cisco Cisco Aironet 3700e Access Point
4-4
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 4 Configuring the Access Point for the First Time
Logging into the Access Point
Logging into the Access Point
A user can login to the access point using one of the following methods:
•
graphical user interface (GUI)
•
Telnet (if the AP is configured with an IP address)
•
console port
Note
Not all models of Cisco Aironet Access Points have the console port. If the access point does not have
a console port, use either the GUI or the Telnet for access.
a console port, use either the GUI or the Telnet for access.
For information on logging into the AP through the GUI, refer to
For information on logging into the AP through the CLI refer to
Obtaining and Assigning an IP Address
To browse to the wireless device Express Setup page, you must either obtain or assign the wireless device
IP address using one of the following methods:
IP address using one of the following methods:
•
If you have a 1040, 1130AG, 1240, 1250, 1260 series access point or a 1300 series access
point/bridge, connect to the access point console port and assign a static IP address. Follow the steps
in the appropriate section to connect to the device console port:
point/bridge, connect to the access point console port and assign a static IP address. Follow the steps
in the appropriate section to connect to the device console port:
–
–
–
–
Note
In some terminal emulator applications you may need to set the Flow control parameter to
Xon/Xoff. If you are not able to console into the device with the flow control value set to none,
try changing the flow control value to Xon/Xoff.
Xon/Xoff. If you are not able to console into the device with the flow control value set to none,
try changing the flow control value to Xon/Xoff.
•
Use a DHCP server (if available) to automatically assign an IP address. You can find out the
DHCP-assigned IP address using one of the following methods:
DHCP-assigned IP address using one of the following methods:
–
Connect to the wireless device console port and use the show ip interface brief command to
display the IP address.
display the IP address.