Cisco Cisco WAP561 Wireless-N Dual Radio Selectable Band Access Point Manual De Mantenimiento
Single Point Setup
Wireless Neighborhood
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
168
10
web interface of a member and select Wireless > Rogue AP Detection in the navigation
pane.
pane.
Wireless Neighborhood
For each neighbor access point, the following information is shown:
•
Display Neighboring APs—Select one of the following radio buttons to change the
view:
view:
-
In cluster—Only neighbor WAP devices that are members of the cluster.
-
Not in cluster—Only neighbor WAP devices that are not cluster members.
-
Both—Shows all neighbor WAP devices (cluster members and nonmembers).
NOTE
For a detected AP that is also a cluster member, only the SSIDs of the default
VAP (VAP0) display as In cluster. Non-default VAPs on the AP display as Not in cluster.
•
Cluster—The list at the top of the table shows IP addresses for all WAP devices that
are clustered together. (This list is the same as the members list on the Single Point
Setup > Access Points page.)
are clustered together. (This list is the same as the members list on the Single Point
Setup > Access Points page.)
If there is only one WAP device in the cluster, only a single IP address column shows,
indicating that the WAP device is grouped with itself.
indicating that the WAP device is grouped with itself.
You can click on an IP address to view more details on a particular WAP device.