Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point Guía De Instalación

To mount the WAP device to a wall or ceiling:

Determine where you want to mount the device. Verify that the 
surface is smooth, flat, dry, and sturdy. 

Drill two pilot holes into the surface 2.75 inches (70 mm) apart for 
your Cisco WAP device. 

Insert a screw into each hole, leaving a gap between the surface 
and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the 
screws accordingly, and slide the bracket down until the screws fit 
snugly into the slots.

Using the bracket as a template, drill two more holes for the lower 
screws.

Insert a screw into each lower hole.

Slide the WAP device into the bracket, placing the cable through 
the break-out tab found in the back of the bracket. 

The default configuration of the device has the Wi-Fi radio turned off.  You 
must perform the initial configuration using a wired Ethernet connection. To 
connect the device to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router, 
or a PC. 

Connect the other end of the network Ethernet cable to the 
Ethernet port of the wireless access point. 

After installation, all lights should be active. Refer to 

 for details about the different lights on each 

switch.