Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point Manual De Mantenimiento
LAN
IPv6 Tunnel
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
57
4
To configure an IPv6 tunnel using ISATAP:
STEP 1
Select LAN > IPv6 Tunnel in the navigation area.
STEP 2
Configure the following parameters:
•
ISATAP Status—Enables or disables the administrative mode of ISATAP on
the WAP device.
the WAP device.
•
ISATAP Capable Host—The IP address or DNS name of the ISATAP router.
The default value is isatap.
The default value is isatap.
•
ISATAP Query Interval—Specifies how often the WAP device should send
queries to the DNS server to attempt to resolve the ISATAP host name into
an IP address. The WAP sends DNS queries only when the IP address of an
ISATAP router is unknown. The valid range is 120 to 3600 seconds.
queries to the DNS server to attempt to resolve the ISATAP host name into
an IP address. The WAP sends DNS queries only when the IP address of an
ISATAP router is unknown. The valid range is 120 to 3600 seconds.
•
ISATAP Solicitation Interval—Specifies how often the WAP should send
router solicitation messages to the ISATAP router(s) it learns about through
the DNS query messages. The WAP sends router solicitation messages only
when there is no active ISATAP router. The valid range is 120 to 3600
seconds.
router solicitation messages to the ISATAP router(s) it learns about through
the DNS query messages. The WAP sends router solicitation messages only
when there is no active ISATAP router. The valid range is 120 to 3600
seconds.
STEP 3
Click Save. The settings are saved to the Startup Configuration.
When the tunnel is established, the ISATAP IPv6 Link Local Address and ISATAP
IPv6 Global Address show on the page. These are the virtual IPv6 interface
addresses to the IPv4 network.
IPv6 Global Address show on the page. These are the virtual IPv6 interface
addresses to the IPv4 network.