Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Manual De Mantenimiento

Management Access Control

Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

37

•

For TFTP, enter the File Name as it exists on the TFTP server and the TFTP 
Server IPv4 Address, then click Upload. The filename cannot contain the 
following characters: spaces, <, >, |, \, : , (, ), &, ; , #, ? , *, and two or more 
successive periods.

A confirmation appears when the upload was successful.

You can create an access control list (ACL) that lists up to five IPv4 hosts and five 
IPv6 hosts that are authorized to access the WAP device configuration utility. If this 
feature is disabled, anyone can access the configuration utility from any network 
client by supplying the correct WAP device username and password.

If the management ACL is enabled, access through the web and SNMP is 
restricted to the specified IP hosts.

Verify any IP address that you enter. If you enter an IP address that does not match 
your Administrative computer, you will lose access to the configuration interface. It 
is highly recommend to give the Administrative computer a static IP address, so the 
address does not change over time.

To create an access list:

Select Administration > Management Access Control in the navigation pane.

Select Enable for the Management ACL Mode.

Enter up to five IPv4 and five IPv6 addresses that will be allowed access.

Verify the IP addresses are correct.

Click Save. The changes are saved to the Startup Configuration.