Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Manual De Mantenimiento

WorkGroup Bridge

Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

90

Before you configure WorkGroup Bridge on the WAP device, note these 
guidelines:

•

All WAP devices participating in WorkGroup Bridge must have the following 
identical settings:

-

Radio 

-

IEEE 802.11 Mode

-

Channel Bandwidth 

-

Channel (Auto is not recommended) 

See 

 (Basic Settings) for information on configuring these settings.

•

WorkGroup Bridge mode currently supports only IPv4 traffic.

•

WorkGroup Bridge mode is not supported across a Single Point Setup.

•

It is not recommended to associate another AP to the downstream interface 
of the WAP device operating in WorkGroup Bridge mode; that is, the 
chaining or cascading of APs is not supported.

To configure WorkGroup Bridge mode:

Select Wireless > WorkGroup Bridge in the navigation pane.

Select Enable for the WorkGroup Bridge Mode.

For WAP561 devices, select the radio interface on which to configure WorkGroup 
Bridge mode (Radio 1 or Radio 2).

Configure these parameters for the Infrastructure Client Interface (upstream):

•

SSID—The SSID of the BSS. 

There is an arrow next to SSID for SSID Scanning; this feature is 

disabled by default, and is enabled only if AP Detection is enabled in Rogue 
AP Detection (which is also disabled by default). 

•

Security—The type of security to use for authenticating as a client station 
on the upstream WAP device. Choices are:

-

-

-