Cisco Cisco WAP561 Wireless-N Dual Radio Selectable Band Access Point Manual De Mantenimiento

VLAN and IPv4 Address Settings

Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

53

If autonegotiation is disabled, select a Port Speed (10/100/1000 Mb/s) and the 
duplex mode (Half- or Full-duplex).

Enable or disable the Green Ethernet Mode. When enabled, the WAP device 
automatically enters a low-power mode when energy on the line is lost, and it 
resumes normal operation when energy is detected.

Click Save. The changes are saved to the Startup Configuration.

You can use the VLAN and IPv4 Address Settings page to configure settings for 
the LAN interface, including static or dynamic IPv4 address assignment.

To configure LAN settings:

Select LAN > VLAN and IPv4 Address in the navigation area.

The page shows Global Settings and IPv4 Settings. The Global Settings area 
shows the MAC address of the LAN interface port. This field is read-only.

Configure these Global Settings:

•

Untagged VLAN—Enables or disables VLAN tagging. When enabled (the 
default), all traffic is tagged with a VLAN ID. 

By default all traffic on the access point uses VLAN 1, the default untagged 
VLAN. This means that all traffic is untagged until you disable the untagged 
VLAN, change the untagged traffic VLAN ID, or change the VLAN ID for a VAP 
or client using RADIUS.

•

Untagged VLAN ID—Specifies a number between 1 and 4094 for the 
untagged VLAN ID. The default is 1. Traffic on the VLAN that you specify in 
this field is not be tagged with a VLAN ID when forwarded to the network.

VLAN 1 is the both default untagged VLAN and the default management 
VLAN. If you want to segregate management traffic from the untagged VLAN 
traffic, configure the new VLAN ID at your router, and then use this new VLAN 
ID on your WAP device.

•

Management VLAN ID—The VLAN associated with the IP address you use 
to access the WAP device. Provide a number between 1 and 4094 for the 
Management VLAN ID. The default is 1.