Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE Manual De Mantenimiento
LAN
LLDP
Cisco WAP571/E Administration Guide
70
4
STEP 1
Select LAN > LLDP in the navigation area.
STEP 2
Configure the following parameters:
•
LLDP Mode—The administrative mode of LLDP on the AP. When LLDP is enabled,
the AP transmits LLDP Protocol Data Units to neighbor devices.
the AP transmits LLDP Protocol Data Units to neighbor devices.
•
TX Interval—The number of seconds between LLDP message transmissions. The
valid range is 5 to 32768 seconds. The default value is 30 seconds.
valid range is 5 to 32768 seconds. The default value is 30 seconds.
•
POE Priority—The priority level transmitted by the AP in the Extended
Power information element. The PoE priority level helps the Power Sourcing
Equipment (PSE), such as a switch, determine which powered devices
should be given priority in power allocation when the PSE does not have
enough capacity to supply power to all connected devices. The PoE priority
can be one of the following:
Power information element. The PoE priority level helps the Power Sourcing
Equipment (PSE), such as a switch, determine which powered devices
should be given priority in power allocation when the PSE does not have
enough capacity to supply power to all connected devices. The PoE priority
can be one of the following:
-
Critical
-
High
-
Low
-
Unknown
STEP 3
Click Save. The settings are saved to the system.