Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Manual De Mantenimiento
Client Quality of Service
Class Map
Cisco WAP571/E Administration Guide
126
8
-
Match to Value—Matches a protocol that is not listed by name. Enter the
protocol ID. The protocol ID is a standard value assigned by IANA. The
range is a number from 0 to 255.
protocol ID. The protocol ID is a standard value assigned by IANA. The
range is a number from 0 to 255.
•
Source IPv6—Requires a packet's source IPv6 address to match the IPv6
address defined in the appropriate fields.
address defined in the appropriate fields.
-
Source IPv6 Address—Enter the IPv6 address to apply this criteria.
-
Source IPv6 Prefix Length—Enter the prefix length of the source IPv6
address.
address.
•
Source Port—Includes a source port in the match condition for the rule. The
source port is identified in the datagram header.
source port is identified in the datagram header.
-
Select From List—Matches a keyword associated with the source port:
ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these keywords
translates into its equivalent port number.
ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these keywords
translates into its equivalent port number.
-
Match to Port—Matches the source port number in the datagram header
to an IANA port number that you specify. The port range is from 0 to
65535 and includes three different types of ports:
to an IANA port number that you specify. The port range is from 0 to
65535 and includes three different types of ports:
0 to 1023-Well-Known Ports
1024 to 49151-Registered Ports
49152 to 65535-Dynamic and/or Private Ports
-
Mask—The port mask. The mask determines which bits are used and
which bits are ignored. Only the hexadecimal digit (0 to 0xFFFF) is
allowed. 1 means the bit matters and 0 means that we should ignore this
bit.
which bits are ignored. Only the hexadecimal digit (0 to 0xFFFF) is
allowed. 1 means the bit matters and 0 means that we should ignore this
bit.
•
Destination IPv6—Requires a packet's destination IPv6 address to match
the IPv6 address defined in the appropriate fields.
the IPv6 address defined in the appropriate fields.
-
Destination IPv6 Address—Enter the IPv6 address to apply this criteria.
-
Destination IPv6 Prefix Length—Enter the prefix length of the
destination IPv6 address.
destination IPv6 address.
•
Destination Port—Includes a destination port in the match condition for the
rule. The destination port is identified in the datagram header.
rule. The destination port is identified in the datagram header.
-
Select From List—Matches the destination port in the datagram header
with the selected keyword: ftp, ftpdata, http, smtp, snmp, telnet, tftp,
www. Each of these keywords translates into its equivalent port number.
with the selected keyword: ftp, ftpdata, http, smtp, snmp, telnet, tftp,
www. Each of these keywords translates into its equivalent port number.