Cisco Cisco WAP561 Wireless-N Dual Radio Selectable Band Access Point Notas de publicación
2
Release Notes
•
CSCuf60672
—
When the WAP551 or WAP561 is factory-reset using the reset button,
the firmware MD5 checksum information of the non-active image is not preserved.
After the AP comes back up, it shows an error message.
After the AP comes back up, it shows an error message.
•
CSCue51459
—
WAP5x1 fails to save a redirect URL in a captive portal instance page
if there are extensions added to the URL path; for example if “/” is added to the end of
the URL.
the URL.
•
CSCuf78127
—After longetivity run, WAP does not send beacon in some SSIDs.
•
CSCuh05128
—DUT crashed when modifying the configuration under 10Mbps Access
Control List (ACL) traffic.
•
CSCue74057
—Problem with IPv6 Radius authentication.
•
CSCui28808
—WPS function for VAP1 does not work.
Open Caveats
These are the open caveats for firmware version 1.0.4.2
Table 1
Open Caveats in Firmware Version 1.0.4.2
Ref Number
Description
CSCud34239
Symptom:
Special characters can be entered for the administrator password, but they do not work.
Workaround:
Use normal characters in the administrator password.
CSCud38345
Symptom:
Loading and refreshing response time occasionally takes longer than 2 seconds.
Workaround:
None.
CSCud33855
Symptom:
The MAC filter list permits identical MAC addresses without displaying a warning
message.
Workaround:
Do not use the same MAC address in the MAC filter list.
CSCud70917
Symptom:
The WMM function does not work with upstream.
Workaround:
This issue does not affect the customer, it is only used for functional integrity.
CSCty22825
Symptom:
Telnet and SSH have been disabled in the GUI and SNMP.
Workaround:
None.
CSCue85888
Symptom:
WDS and WGB can be enabled at the same time, but this should not be allowed.
Workaround:
None, an error message should be issued for this condition.