Cisco Cisco Aironet 1200 Access Point Referencia técnica

The IOS command line on the WDS host can be used to validate the configurations. To validate the WDS 
configuration, enter this command:

show wlccp wds ap

All of the registered access points and infrastructure access points are listed. For example:

wds-ap# show wlccp wds ap

MAC-ADDR IP-ADDR STATE LIFETIME

000d.28f2.33ea 10.1.12.19 REGISTERED 171 

000d.28f2.3426 10.1.12.23 REGISTERED 173 

000d.28f2.3436 10.1.12.22 REGISTERED 183 

000c.8576.326e 10.1.12.18 REGISTERED 497 

To validate that the CiscoWorks WLSE is correctly registered, enter this command:

show wlccp wnm status

The CiscoWorks WLSE IP address is listed, and “Security Keys Setup" appears in the Status field. 

wds-ap# show wlccp wnm status

WNM IP Address : 172.20.98.221 Status : SECURITY KEYS SETUP

In this section, the configuration tasks required to configure the switch-based WDS solution are covered. 
These tasks include the following:

Configuring the Catalyst 6500 Supervisor 720

Configuring the WDS on the WLSM module

Configuring the infrastructure access point

Managing the access points with the CiscoWorks WLSE

Validating the setup

The required configuration tasks for the Supervisor 720 are as follows:

Configure a VLAN between the supervisor and WLSM

Configure the multi-point GRE tunnel interfaces

Configure SNMP communities

Follow these steps to complete the tasks:

Gain access to the supervisor command-line interface and enter configuration mode.