Cisco Cisco Aironet 1200 Access Point Referencia técnica
Cisco Structured Wireless-Aware Network (SWAN) Implementation Guide
Implementing the Cisco SWAN Framework
29
Cisco Structured Wireless-Aware Network (SWAN) Implementation Guide
OL-6217-01
Subsequent to these steps, customers can configure additional parameters like VLANs, SSIDs, and
encryption settings. Customers may choose to use the CiscoWorks WLSE to do these configurations in
bulk after the CiscoWorks WLSE has discovered the WDS-host and the infrastructure access points.
encryption settings. Customers may choose to use the CiscoWorks WLSE to do these configurations in
bulk after the CiscoWorks WLSE has discovered the WDS-host and the infrastructure access points.
Managing the WLSM and Access Points with the CiscoWorks WLSE
When WLSM is active and all of the infrastructure access points are registered, the access points must
be discovered and managed on the CiscoWorks WLSE. Follow these steps to manage the WLSM:
be discovered and managed on the CiscoWorks WLSE. Follow these steps to manage the WLSM:
Step 1
Log into the CiscoWorks WLSE.
Step 2
Navigate to Devices > Discover. Select Managed/Unmanaged in the table of contents on the left-hand
side.
side.
Step 3
The WLSM WDS device displays in the New folder on the right-hand side action pane.
Step 4
Select the WLSM and then Manage. The negotiation of security between the WDS and CiscoWorks
WLSE begins. After the encryption keys are negotiated, the WDS is interrogated. The WDS device
reports its registered access points to the CiscoWorks WLSE. The CiscoWorks WLSE then interrogates
the registered access points. This process may take 5 to 10 minutes depending on the number of access
points.
WLSE begins. After the encryption keys are negotiated, the WDS is interrogated. The WDS device
reports its registered access points to the CiscoWorks WLSE. The CiscoWorks WLSE then interrogates
the registered access points. This process may take 5 to 10 minutes depending on the number of access
points.
The infrastructure access points are managed in the CiscoWorks WLSE by completing Steps 2 through 4.
Note
This procedure is unnecessary if the advanced discovery auto-manage option was configured prior to
WDS-host discovery.
WDS-host discovery.
Validating the Setup
The IOS command line on the WLSM is used to validate the configurations. To validate the WDS
configuration, enter this command:
configuration, enter this command:
show wlccp wds ap
All registered access points and infrastructure access points are listed.
wlsm# show wlccp wds ap
MAC-ADDR IP-ADDR STATE LIFETIME
000d.28f2.33ea 10.1.12.19 REGISTERED 171
000d.28f2.3426 10.1.12.23 REGISTERED 173
000d.28f2.3436 10.1.12.22 REGISTERED 183
000c.8576.326e 10.1.12.18 REGISTERED 497
To validate that the CiscoWorks WLSE is correctly registered, enter this command:
show wlccp wnm status
The CiscoWorks WLSE IP address is listed and Security Keys Setup appears in the status field.
wlsm# show wlccp wnm status
WNM IP Address : 172.20.98.221 Status : SECURITY KEYS SETUP