Cisco Cisco Aironet 1200 Access Point Notas de publicación
2
Release Notes for Cisco Aironet Conversion Upgrade Image 1.1 for Cisco IOS Software
OL-4641-01
Introduction
Introduction
The Cisco IOS Conversion Upgrade Image for Cisco Aironet 1200 Series Access Points converts a 1200
series access point system from non-IOS to Cisco IOS Release 12.2(11)JA1.
series access point system from non-IOS to Cisco IOS Release 12.2(11)JA1.
When you use the upgrade image with the Cisco Aironet Conversion Tool for Cisco IOS Software, the
upgrade image and the conversion tool maintain the access point configuration while converting the
access point system to IOS operation. When you load the upgrade image onto an access point without
using the conversion tool, the upgrade image converts the access point system to IOS software with all
settings at factory defaults.
upgrade image and the conversion tool maintain the access point configuration while converting the
access point system to IOS operation. When you load the upgrade image onto an access point without
using the conversion tool, the upgrade image converts the access point system to IOS software with all
settings at factory defaults.
System Requirements
To successfully complete the upgrade process, your 1200 series access point must meet these
requirements:
requirements:
•
Your access point must run VxWorks version 12.03T, 12.02T1, 12.01T1, 12.00T, 11.23T, or 11.21
Note
The upgrade image and the conversion tool do not support VxWorks version 12.04. Access
points running operating system version 12.04 must be downgraded to a supported operating
system version before using the upgrade image or the conversion tool.
points running operating system version 12.04 must be downgraded to a supported operating
system version before using the upgrade image or the conversion tool.
•
Your access point must have at least 4 MB of free memory. To ensure that the access point has
enough free memory, set the Maximum memory reserved for Detailed Event Trace Buffer
(bytes) setting on the Event Handling Setup page to 0.
enough free memory, set the Maximum memory reserved for Detailed Event Trace Buffer
(bytes) setting on the Event Handling Setup page to 0.
Note
Cisco Aironet 340 and 350 Series Access Points do not support IOS software. Do not attempt to load the
upgrade image on 340 and 350 series access points.
upgrade image on 340 and 350 series access points.
Finding the Software Version
On 1200 series access points that do not run IOS software, the software version appears in red at the top
left of most pages in the web-browser interface. The home page on access points not running IOS
software looks like the page in
left of most pages in the web-browser interface. The home page on access points not running IOS
software looks like the page in
.