Cisco Cisco Aironet 1200 Access Point Notas de publicación
6
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)XR1
OL-6047-02
Installation Notes
Figure 1
Improper Power Configuration Using Two Power Sources
Operating 5-GHz Radio Requires Power Injector, Power Module, or Catalyst 3550-24 PWR Switch
The 1200 series power injector and the 1200 series power module support operation of the 5-GHz radio
in the access point. Currently, the Catalyst 3550-24 PWR switch supports power for both the 2.4-GHz
radio and the 5-GHz radio. Other switches and power patch panels might not provide enough power for
the 5-GHz radio.
in the access point. Currently, the Catalyst 3550-24 PWR switch supports power for both the 2.4-GHz
radio and the 5-GHz radio. Other switches and power patch panels might not provide enough power for
the 5-GHz radio.
Access Point Requires 1200 Series Universal Power Supply and Power Injector
The 350 series universal power supply and power injector are not compatible with the 1200 series access
point. If you use a power injector or a power module to provide power to a 1200 series access point, you
must use a 1200 series universal power supply. If you need to use a power injector to inject power into
the access point’s Ethernet port, you must use a 1200 series power injector.
point. If you use a power injector or a power module to provide power to a 1200 series access point, you
must use a 1200 series universal power supply. If you need to use a power injector to inject power into
the access point’s Ethernet port, you must use a 1200 series power injector.
Unpowered 1100 Series Access Points Cause Loopback When Connected to Switches Without
Loopback Detection
Loopback Detection
When you connect an unpowered 1100 series access point to a switch without loopback detection, the
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
Universal
power supply
SYST
RPS
DUPLX
MODE
SPEED
UTIL
STAT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
23
24
10Base-T / 10
0Base-TX
100Base-FX
Catalyst 2950
SERIES
Switch with
inline power or
power patch panel
Access point
74329