Cisco Cisco Aironet 1200 Access Point Notas de publicación
4
Release Notes for Cisco Aironet 350, 1100, 1130AG, 1200, and 1230AG Series Access Points for Cisco IOS Release 12.3(2)JA2
OL-6252-02
System Requirements
Step 3
Click Apply at the bottom of the page.
Step 4
If your access point has two radios, repeat these steps for the second radio.
Beginning in privileged EXEC mode, follow these steps to disable the access point radios using the CLI:
If your access point has two radios, repeat these steps for the second radio. Use the no form of the
shutdown command to enable the radio.
shutdown command to enable the radio.
Converting to Cisco IOS Software
If your 350 or 1200 series access point does not run IOS software, you can use the conversion utility or
the conversion upgrade image to convert the access point system to IOS software. Use the conversion
utility to maintain the current configuration after the conversion, or load the upgrade image to convert
to IOS software without saving the current configuration. Your access point must be running one of these
VxWorks firmware versions before you can convert to IOS software:
the conversion upgrade image to convert the access point system to IOS software. Use the conversion
utility to maintain the current configuration after the conversion, or load the upgrade image to convert
to IOS software without saving the current configuration. Your access point must be running one of these
VxWorks firmware versions before you can convert to IOS software:
•
350 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 11.23T, or
11.21
11.21
•
1200 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 12.00T,
11.56, or 11.54T
11.56, or 11.54T
The conversion upgrade image for 350 series access points installs Cisco IOS Release 12.2(13)JA1 on
your 350 series access point. The conversion upgrade image for 1200 series access points installs Cisco
IOS Release 12.2(13)JA2 on your 1200 series access point.
your 350 series access point. The conversion upgrade image for 1200 series access points installs Cisco
IOS Release 12.2(13)JA2 on your 1200 series access point.
Note
The upgrade image and the conversion tool do not support VxWorks version 12.04. Access points
running version 12.04 must be downgraded to a supported operating system version before you can use
the upgrade image or the conversion tool.
running version 12.04 must be downgraded to a supported operating system version before you can use
the upgrade image or the conversion tool.
Note
The upgrade to Cisco IOS software is permanent; you cannot revert to non-IOS software. Product
warranties do not cover unintended upgrades.
warranties do not cover unintended upgrades.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface dot11radio {0 | 1}
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
Step 3
shutdown
Disable the radio port.
Step 4
end
Return to privileged EXEC mode.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.