Cisco Cisco Aironet 1200 Access Point Manual De Mantenimiento
2
Release Notes for Cisco Aironet Conversion Tool for Cisco IOS Software, 2.0 for Windows
OL-5177-01
Introduction
Introduction
The conversion tool is a special utility that is used by administrators to do the following:
•
Create a Cisco IOS configuration using the configuration of an existing non-IOS 350 or 1200 series
access point. Store a Cisco IOS configuration file on your PC for later use.
access point. Store a Cisco IOS configuration file on your PC for later use.
•
Upgrade non-IOS 1200 series access points to Cisco IOS operation by combining the Cisco IOS
configuration file with a 1200 series helper image. Converts the access point to Cisco IOS Release
12.2(11)JA1.
configuration file with a 1200 series helper image. Converts the access point to Cisco IOS Release
12.2(11)JA1.
•
Upgrade non-IOS 350 series access points to Cisco IOS operation by combining the Cisco IOS
configuration file with a 350 series helper image. Converts the access point to Cisco IOS Release
12.2(13)JA1.
configuration file with a 350 series helper image. Converts the access point to Cisco IOS Release
12.2(13)JA1.
To find your access point software release (Cisco IOS or non-IOS) refer to the
.
Caution
The conversion tool cannot reverse the Cisco IOS upgrade process. Be sure that you want to upgrade
your access point to Cisco IOS operation before using the conversion tool.
your access point to Cisco IOS operation before using the conversion tool.
System Requirements
The conversion tool has the following system requirements:
Note
The conversion tool does not support Non-IOS 350 and 1200 series access points running operating
system version 12.04. Access points running operating system version 12.04 must be downgraded to a
supported operating system version before using the conversion tool.
system version 12.04. Access points running operating system version 12.04 must be downgraded to a
supported operating system version before using the conversion tool.
•
Non-IOS 350 series access points running operating system version 12.03T, 12.02T1, 12.01T1,
11.23T, and 11.21.
11.23T, and 11.21.
•
Non-IOS 1200 series access points running operating system version 12.03T, 12.02T1, 12.01T1,
12.00T, 11.56, or 11.54T.
12.00T, 11.56, or 11.54T.
•
The conversion tool operates only on a PC with the Windows 2000 or XP operating system.
•
The conversion tool requires the following minimum PC hardware:
–
Processor: Pentium III or equivalent
–
Speed: 850 MHz
–
RAM: 128 MB
–
Hard disk free space: 250 MB (4 MB for each helper image upgrade task)
When using the minimum PC hardware, the conversion tool supports up to 14 parallel helper image
upgrades. You can enter up to 20 tasks, but only 14 of the tasks (maximum) can be helper image
upgrades, and the remaining tasks can be used to store the access point’s Cisco IOS configurations
on your hard disk. Prior to starting multiple helper image upgrade tasks, you should verify that your
PC has sufficient disk space.
upgrades. You can enter up to 20 tasks, but only 14 of the tasks (maximum) can be helper image
upgrades, and the remaining tasks can be used to store the access point’s Cisco IOS configurations
on your hard disk. Prior to starting multiple helper image upgrade tasks, you should verify that your
PC has sufficient disk space.