Cisco Cisco Aironet 1200 Access Point Notas de publicación
11
Resolved Caveats
OL-3077-01
Troubleshooting
•
CSCdw83703—The access point sometimes reports this error when LEAP-enabled workgroup
bridges are associated:
bridges are associated:
Could not allocate mBlk from netPool 0x00d0a5a8!
You can ignore this message.
•
CSCdx92461—Hot Standby mode is available only for the 2.4-GHz radio in access points that
contain two radios. Hot Standby mode is not available for 5-GHz radios.
contain two radios. Hot Standby mode is not available for 5-GHz radios.
•
CSCdx93214—Broadcast key rotation does not work on second-level repeater acess points. For
example, in a repeater chain consisting of a root access point, a repeater access point associated to
the root, and a second repeater associated to the first repeater, the second repeater cannot pass data
when brodacast key rotation is enabled. If additional repeater access points are added to the chain,
they also cannot pass data when broadcast key rotation is enabled.
example, in a repeater chain consisting of a root access point, a repeater access point associated to
the root, and a second repeater associated to the first repeater, the second repeater cannot pass data
when brodacast key rotation is enabled. If additional repeater access points are added to the chain,
they also cannot pass data when broadcast key rotation is enabled.
Resolved Caveats
The following caveat has been resolved in firmware version 11.50T:
•
CSCdy18881—Access points no longer revert to the North American country code when reset to
factory defaults.
factory defaults.
•
CSCdw36550 and CSCdx13824—With all data rates enabled, the access point’s Linktest feature no
longer sends all test packets at the highest available data rate. As attenuation increases (signal
strength decreases), the access point now sends test packets at lower data rates as it should.
longer sends all test packets at the highest available data rate. As attenuation increases (signal
strength decreases), the access point now sends test packets at lower data rates as it should.
•
CSCdw42125—The access point no longer attempts to send MAC authentication requests to the
server before the network is ready.
server before the network is ready.
•
CSCdw64319—When you enter the SNMP command sysObjectID, the access point is now
properly identified as ciscoAIRAP1200.
properly identified as ciscoAIRAP1200.
•
CSCdx87342—IP phones set to Max PSP now respond to signals from a 1200 series access point.
•
CSCdx89832—When you access the management system on a 1200 series access point through the
console port, the access point now always displays both the prompt for a username and a password
when User Manager is enabled.
console port, the access point now always displays both the prompt for a username and a password
when User Manager is enabled.
Troubleshooting
For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at
. Select Wireless Technologies under Top Issues.