Cisco Cisco Aironet 1200 Access Point Notas de publicación

When you are ready to download the firmware, go to the Standard Installation section and click Access 
Point Bundle. The Aironet Software Selector encryption authorization form appears.

Complete the required fields on the authorization form and check the boxes indicating agreement with 
the download agreement.

Type your name exactly as you entered it in the First Name and Last Name fields.

Click Submit. The Software Download Software License Agreement page appears.

Review the license agreement and click Accept. The File Download window appears.

Click Save and select a location at which to save the file.

To upgrade firmware from a file server, you must enter settings on the access point’s FTP Server Setup 
page. Refer to the 

 in the Cisco Aironet 1200 Series 

Access Point Software Configuration Guide for more information.

This section describes limitations and restrictions for 1200 series access points.

When you update the firmware on an access point, allow the unit to finish its start-up sequence before 
removing power. 

If you update the firmware and remove power before the unit finishes the start-up sequence, the radio 
firmware might be corrupted making the unit inoperable.

If the radio firmware is corrupted, the radio indicator (the bottom of the three indicators on top of the 
access point) is red continuously, and the following error message appears when the access point starts 
up:

Failed to start driver for port “awc0” (errno=0x006d0002)

The access point should recover from this error automatically.

You can safely shut off power after a firmware update when the configuration management pages 
reappear in the command-line or web-browser interfaces or when the three status indicators on top of the 
unit complete the following pattern:

All three indicators are continuously green, meaning that the access point is beginning to update the 
firmware.

The middle indicator is continuously green and the top and bottom indicators are off, indicating that 
the access point is updating the radio firmware. 

When the middle indicator blinks or the top and bottom indicators blink, you can shut off power.