Cisco Cisco Aironet 701e Access point Guía De Instalación
14
11
Declarations of Conformity and Regulatory Information
This section provides declarations of conformity and regulatory information for Cisco Aironet 700 Series Access Points. You
can find additional information at this URL:
can find additional information at this URL:
www.cisco.com/go/aironet/compliance
Manufacturers Federal Communication Commission Declaration of Conformity
Statement
Statement
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired operation.
This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore restricted to indoor operation only per
FCC guidance.
FCC guidance.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used
in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one of the following measures:
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used
in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician.
Caution
The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when
using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could
void the user’s authority to operate this device.
using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could
void the user’s authority to operate this device.
Models
Certification Numbers
AIR-CAP702I-A-K9
AIR-SAP702I-A-K9
AIR-SAP702I-A-K9
AIR-SAP702I-B-K9
AIR-AP702I-UXK9
LDK102085