Cisco Cisco Transport Manager 9.0 Referencia técnica

The enable L2 service command has been enhanced. (See the section “Enabling Layer 2 Services” in 
Chapter 7, “Provisioning Services and Connections” in the 

)

The enable L2 service command is used only when the resynchronization status of the topology is 
L2 Service Not Ready, and its main purpose is to change the Layer 2 topology into a resynchronization 
status of Complete so that a VLAN can be created.

Instead of commanding the default base card configuration on all ML-series cards in the topology to be 
downloaded, this command downloads a customized base card configuration on only the selected Layer 
2 topology ML-series cards that do not have the customized configuration and are in a synchronized 
configuration state (barebone file downloaded).

This command applies to point-to-point, Cisco RPR, and 802.17 RPR Layer 2 topologies.

You can access the most current CTM R9.0 documentation online at 

.

The CTM documentation set comprises the following guides:

—Describes the caveats for CTM.

—Explains how to install CTM and how to 

upgrade from previous releases.