Cisco Cisco 7815I Media Convergence Server Manual Técnica
Configuring a Single Dialed Number to Route Calls
to a Group of IP Phones
to a Group of IP Phones
Document ID: 13932
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configuration Choices for Cisco CallManager 3.x
Group Dialed Number
Hunt Groups
Attendant Console
Configuration Choices for Cisco CallManager 4.x
Group Dialed Number
Hunt Groups
Attendant Console
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configuration Choices for Cisco CallManager 3.x
Group Dialed Number
Hunt Groups
Attendant Console
Configuration Choices for Cisco CallManager 4.x
Group Dialed Number
Hunt Groups
Attendant Console
Related Information
Introduction
This document explains how to configure a single dialed number (DN#) that is associated with a group of IP
phones.
phones.
Prerequisites
Requirements
Cisco recommends you have knowledge of Cisco CallManager 3.x and 4.x.
Components Used
The information in this document is based on these software and hardware versions:
Cisco CallManager version 3.3
•
Cisco CallManager version 4.0
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.